Kommentare zu: BOINCpe – FAQ

Von: Ogre2000

Ogre2000 — Wed, 08 Sep 2010 19:31:00 +0000

Hello again.
Is any tool, works under BartPE, which could show motherboard serialnumber from commandline?

Von: Ogre2000

Ogre2000 — Wed, 08 Sep 2010 12:09:00 +0000

HEllo.
It is good solution. But I need to change vomputer name. If I don’t have choosen any computername in ini file the computername is eg. “bartpe-234234″, but I need to have got eg. “SAH-234221″ computername. But if I entry manually computername eg. “SAH” in ini file, the computer has only “SAH” name without numbers. What I need to do for works well?

Von: Torben

Torben — Wed, 08 Sep 2010 09:09:00 +0000

Hi Chungen,

please give it some time for the different computer names. Hopefully, there will be a way in the next version of BOINCpe…

There is no PXE tutorial on this site, yet. I suppose you mean the one in the “Meisterkühler” board? The thread switched to English from this post on.
I did not have the time to test it, yet. The main problem seems to be related to the QSoft Ramdisk making trouble when booted via PXE…

There is no specific board in place. You are welcome to ask your questions either here or in the official BOINC board…

Cheers,
Torben

Von: Chungen Hung

Chungen Hung — Wed, 08 Sep 2010 07:19:00 +0000

Is there a way to automatically assign DIFFERENT computer name?
For example, if this PC have a MAC address of 30-34-M3-34-E3 then assign its computer name as PC5.

In addition, is there a translation of the German tutorial of how to run BOINCpe over network (PXE)?

One last question, where is the best place to ask questions regarding BOINCpe? Is there a discussion board here?

Von: Thomas Walton

Thomas Walton — Wed, 08 Sep 2010 01:12:00 +0000

@Torbin: Yes, I detached all from Riesel as it seemed to be a problem project.

@BrnmccO1:I added ‘shutdown’ after “start boinc … /wait …”

I didn’t get around to adding automatic (every 15 minutes or so) reattempts to the persistancy service on failure, so the system doesn’t shutdown when the persistancy service fails.

launch_boinc.bat

@ECHO OFF

start “Boinc” /min /low /wait %BOINCclient%\boinc.exe -return_results_immediately -allow_remote_gui_rpc -dir %BOINCdata%
ShutDown

rem if not exist %BOINCbase%\Persistency goto end
rem start /D%BOINCdata% %BOINCclient%\boincmgr.exe

:end
EXIT

shutdown.cmd (needs modification to reattempt persistancy)

@ECHO OFF

if not exist %BOINCbase%\Persistency goto local

CALL %BOINCbase%\Persistency\persist_BOINC_data.bat
if not %ERRORLEV%==0 goto abort